Understanding The Digital Control Center - Louisiana Grills LG860C Instructions And User Manual

UNDERSTANDING THE DIGITAL CONTROL CENTER

This P.I.D. (proportional-integral-derivative) control is very much the same as the controls on your kitchen oven. The main
advantages are the ability to automatically compensate for the different ambient conditions and fuel types.
IMPORTANT: The temperature inside of any grill will vary greatly from location to location. Even instruments calibrated
together may not agree with each other.
CONTROL
On / Off Touch Pad
Prime Touch Pad
Temp Adjust Touch Pad
LED Screen
Temp Touch Pad
Probe Touch Pad
Meat Probe Connection Port
15
DESCRIPTION
Press the touch pad to turn the control on, which begins the automatic start-up
cycle. Also used to turn the unit off, activating the cool-down cycle.
Press and hold this touch pad to activate an extra feed of pellets to the burn grate.
This can be used to add more fuel just before opening the grill lid, resulting in a quicker
heat recovery time. It can also be used to add more fuel while smoking, to increase the
amount of clean smoke flavor intensity. Requested from the competition cookers.
By pressing the UP or DOWN arrows, the temperature displayed on the LED read-out
can be adjusted by 5 degree increments. The temperature can be set to a low 82°C /
180°F, and peaks at a high of 315°C /600°F. Also used to adjust the desired temperature
of the meat probe.
This screen is used to display temperature read-outs and error messages. Temperature
can be displayed in either Fahrenheit or Celsius.
By pressing the TEMP display touch pad, the LED display screen will show the ACTUAL
temperature or the SET POINT temperature. The small LED beside both settings is
used to indicate which temperature is presently being displayed.
By pressing the PROBE display touch pad, the LED display screen will show the GRILL
probe temperature or the MEAT probe temperature. The small LED beside both
settings is used to indicate which probe temperature is presently being displayed.
Plug-in connection port for the programmable meat probe. When
connected, the temperature is monitored by the digital control
center. When not in use, disconnect the meat probe from the
connection port.