Table of Contents
Advertisement
•
Do not install the system in the following locations:
–
Areas where shocks or vibrations are frequent or strong. Such activity may lead to the product falling
over and causing injury, or may impair the product's performance.
–
Areas with high amounts of dust. High amounts of dust can lead to fire or electric shock, and impair
the performance of the product.
•
Do not connect or disconnect the AC plug with wet hands.
•
Do not touch the Trunk Adaptor, AC adaptor or AC adaptor cord during a lightning storm.
•
Do not allow anything to rest on the AC adaptor cord or LAN cable. Do not locate the Trunk Adaptor where
the AC adaptor cord or LAN cable may be stepped on or tripped on.
•
When installing the Trunk Adaptor with an external AC adaptor, the AC adaptor should be plugged into a
wall outlet or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as
the weight of the adaptor may cause it to become disconnected.
•
Make sure that you do not short the cables.
•
Never attempt to insert wires, pins, etc. into the vents or other holes of the Trunk Adaptor.
•
Do not splash water on the AC adaptor or the AC adaptor cord, nor get them wet. Doing so can result in
fire, electric shock, or injury. If they do get wet, immediately disconnect the AC adaptor, and contact an
authorised service centre.
•
Do not touch the AC adaptor for extended periods of time. Doing so can lead to low-degree burns.
•
Do not make power connections that exceed the ratings for the AC outlet or power equipment. If the power
rating is exceeded, it can cause a fire due to heat buildup.
•
Care should be taken so that objects do not fall onto, and liquids are not spilled into, the Trunk Adaptor.
Do not subject the Trunk Adaptor to excessive smoke, dust, moisture, mechanical vibration, shock, or direct
sunlight.
•
Do not place heavy objects on top of the Trunk Adaptor.
•
Do not mount the Trunk Adaptor in a manner other than that described in this manual.
•
The Trunk Adaptor must only be installed and serviced by qualified service personnel. The Trunk Adaptor
should be used as-is from the time of purchase; it should not be disassembled or modified. Disassembly
or modification can cause a fire, electric shock, or damage to the Trunk Adaptor.
•
Make sure that the wall that the Trunk Adaptor will be attached to is strong enough to support the Trunk
Adaptor (approx. 500 g). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers) included with the Trunk Adaptor.
•
Be careful not to drop any components. Dropping components may damage them or cause an injury.
•
Disconnect the Trunk Adaptor from the AC outlet, disconnect the LAN cable, and contact the dealer if:
–
The AC adaptor cord or AC plug becomes damaged or frayed.
–
The Trunk Adaptor is exposed to rain, water, or any other liquid.
–
The Trunk Adaptor is dropped or damaged.
–
Internal components are exposed due to damage.
–
The Trunk Adaptor does not operate properly.
–
Performance deteriorates.
WARNING
1.1 For Your Safety
Installation Manual
7
Hide quick links:
Advertisement
Table of Contents
