JMC Soundboard User Manual page 9

3. Loosen the lower screw on the fixation element (figure 2).
4. Insert the adjustment tool (figure 3) on the fixation element (figure 4) and set it horizontally, first by adjusting
the level and secondly by firmly pressing the two horizontal bars of the tool against the wall (figure 3).
5. Block the lower screw (figure 2) by using the provided 4 mm Allen screwdriver (figure 5).
6. Remove the JMC Soundboard from the box and place it flat on the floor.
Attention, spruce wood is very tender and can easily be marked.
7. Prepare the 4-wire speaker cable. For installations with visible cables, place
the cable in the ring of the fixation element (figure 6), and insert the plugs
on the back of JMC Soundboard. In the case of an in-wall cable installation,
use the hole in the wall fixation and then move it into the ring.
8. Remove the protective rails, and slide the female part of the fixation located on the back of the
JMC Soundboard into the fixation element on the wall until it is completely fixed. Insert the speaker
cable plugs into the JMC Soundboard. It is recommended to connect the cable before attaching the
JMC Soundboard against the wall, because access to the rear can become difficult at a later stage...
9. Tighten the 2 screws of the female part of the fixation element (figure 6) using the supplied tool (4 mm Allen
screwdriver, Figure 5). This tightening is only possible with the supplied tool.
Now the installation is complete and you are ready to enjoy your musical instrument of the 21
Remark
- The JMC Soundboard is suspended so as to enable the vibrations to travel throughout the membrane (and
not be dissipated through the wall mount or in the wall). It should therefore normally enjoy a certain degree
of freedom when suspended.
www.jmclutherie.com
Figure 6
st century.
Page | 9