Switching To The Temporary Light Mode; View The Schedule For Each Daily Light Mode - Robo-Tank Basic User Manual

Robo-Tank DIY All-In-One Aquarium Controller User Manual

Switching to the Temporary Light Mode

will exit the temporary light mode and return to the normal mode.
You can also change the range of the sliders from Low to High as discussed above.

View the Schedule for Each Daily Light Mode

Sun to Mid Sun which takes 1 minute this time, this is quite extreme as an example.
The lights now stay in the Mid Sun mode until 2:02pm when they start transitioning to High Sun and takes 30 minutes to
complete. They now stay at High Sun until 7:00pm and start transitioning back down to Mid Sun, this takes 1 Hour. Then it
goes from Mid Sun to Low Sun starting at 11:00pm and lasts for 30 minutes and finally at 11:31 it starts transitioning back to
Night, it shuts off completely at 1:31am.
This is the cycle that will run daily, if you press any one of the 6 transitions you can adjust the start time and length of time,
the transition runs for.
Robo-Tank DIY All-In-One Aquarium Controller
From the Home screen press: Lights, and you the
TEMPORARY LIGHT MODE screen, to the left, you
can start and adjust the temporary light mode.
Using the temporary light mode bypasses the daily
light schedule. When you enter the screen the
sliders go to the current LED intensity for each
channel, if you adjust them the light intensity
changes.
Press the Set Temporary Light Mode, in the bottom
left hand corner to keep the lights in this mode. If
you don't press that button and exit the screen the
lights resume to how they were.
Pressing Resume on the Home screen for 1 second
From the home screen press Settings > Schedules >
Lights and you get the LIGHT SCHEDULE screen
where you can view the schedules for each of the 4
daily light modes.
You can see on the left that the lights come on at
11:00am and start transitioning from Night to Low
Sun, this means the controller slowly brightens
from Night mode to Low Sun mode, in this case it
will take 1 hour and 30 minutes before the lights hit
the intensity values selected for Low Sun mode, this
will happen at 12:30pm.
Then the lights stay at the Low Sun intensity until
1:31pm when the lights start transitioning from Low
Back to Top User Manual v4.05 – Page 27