Using The Stove Guard - SAFERA Airis User Manual

3. Using the Stove Guard

Safera Stove Guard observes the tem-
perature changes and the use of the
cooker. The Stove Guard automatically
gives an alarm and switches off the
cooker and the oven in a hazardous sit-
uation based on temperature changes
and also if
• the cooker is left on for over 3 hours
without anyone using it,
• the cooker has been on for over 5
hours, or
• the oven has been on for over 12
hours without anyone using it.
3.1 Setting the Alarm Limit
To ensure safe and reliable operation,
you need to set the alarm limit to match
the location of the cooker in the kitchen.
The alarm limit may also be adjusted in
case of frequent false alarms. See Instal-
lation manual for further information.
ѥ WARNING
The Stove Guard is controlling the
oven only if the oven is connected to
the power control unit Ⓒ.
The cooker's hot-hob indicators do
not work after the Stove Guard has
switched off the cooker. The hobs
may still be hot.
⚐ ATTENTION
The Stove Guard is designed to avoid
raising unnecessary alarms. This
means that it allows the temperature
to rise quite high during cooking
without raising an alarm.
6
⚐ ATTENTION
It does not sound an alarm until it
looks like the situation may cause
danger to the surroundings.
3.2 Automatic Child Proof Lock
By default, automatic child proof lock is
disabled. You can enable it by pressing
the adjustment button ❶ for 5 seconds
until you hear two high beeps (••) and
the indicator light ❹ blinks green twice.
This way you can also disable the auto-
matic child proof lock (one low signal
with indicator light ❹ blinking red).
Automatic child proof lock will prevent
using the cooker and oven approx. 10 -
60 minutes after the cooking is finished.
To use the cooker when the automatic
child proof lock is enabled, press the
OK button ❸ first and then turn on the
cooker. If the OK button is not pressed
first, the automatic child proof lock will
switch off the cooker power in five sec-
onds.
3.3 Other safety features
For safety reasons, the stove guard will
prevent the use of cooker and oven, if
• the sensor unit Ⓐ is removed from
its' original installation position:
place the sensor unit back to the
mounting bracket
Ⓑ
• the batteries are empty: replace the
batteries (see chapter 4.3)
• if the sensor unit is Ⓐ faulty: see
chapter 6. troubleshooting.
3.4 Cooker danger
Warning for dangerously hot cooker or
for leaving the cooker or the oven on for
too long. An alarm is sounded and indi-
cator light ❹ is flashing red. The Stove
Guard switches off the cooker and the
oven in 15 seconds. When you hear the
alarm:
1. Check the situation calmly. If there
is no danger, you can prevent the
cooker power switch off by pressing
the OK button ❸ during the alarm
and continue with cooking.
2. If you do not press the OK button ❸
during the alarm, the Stove Guard
will switch off the cooker and the
oven: after swith off a repetitive
signal is sounded and the indicator
light ❹ is blinking red for 15 minutes.
3. When there is no more danger, you
can return the power to the cooker
and oven by pressing the OK button
❸. First, turn the hob switches to the
zero position.
4. Ensure that the hazardous situation
will not recur.
ѧ HINT
If the case of frequent false alarms,
you can raise the alarm limit, see 3.1.
3.5 Water Leakage Detector
(optional)
Safera Stove Guard can be equipped
with max. four water leakage sensors.
When the sensors get wet for exam-
ple because water drips on them, the
detector will sound an alarm with far-
spaced signals and indicator light ❹ is
blinking blue.
When you hear the water leakage alarm:
1. Reset the alarm by pressing the OK
button ❸.
2. Before continuing, make sure the
power supply for the cooker is
turned off.
3. Find out what caused the alarm and
take care of the water leakage.
4. Clean and dry the sensor Ⓕ.
ѧ HINT
If the sensor is left wet, the appliance
will give another alarm in 8 hours af-
ter signing off the previous one.
7