Table of Contents
Advertisement
CHAPTER 4 GUIDE TO OPERATION
4.1 INSTALLATIONS
• To start operation on drive.
Turn on the power supply of Host PC.
Plug the USB interface cable of the SuperDisc drive to Host PC USB port.
(Refer the previous page)
Insert a disk into the disk slot with the disk's label facing up and the shutter side
heading as shown in the below figure.
CAUTION:
• Do not insert any foreign objects into the disk slot. This could result in a
malfunction.
• Do not press down hard on a disk when inserting the disk, because this may cause
damages or malfunction to the disk and/or the drive unit.
• In case of emergency, eject the disk manually
If for some reason the disk does not eject automatically,
press the eject-bar (for example, insert a straightened paper
clip pin with minimum straight length = 15 mm, Diameter =
0.5 ~ 0.8 mm) into the emergency eject hole to eject the disk.
(Before proceeding with this emergency step, make sure
that the power is switched OFF.)
A-6
Min. 15 mm
Paper clip pin
Advertisement
Table of Contents
