Changing The Protection Grid; Changing The Protection Grid At The Back; Changing The Protection Grid On The Bottom - Vorwerk Thermomix TM5 Instruction Manual

CHANGING THE
PROTECTION GRID
Accessory in selected countries

Changing the protection grid at the back

Disconnect the Thermomix from the mains. Remove the ventilation grille
®
by lifting it from the clips at the recessed grip 1 . You will now see the back
of the Thermomix ® with the ventilation slits 2 . Take the protection grid
for the back 3 and insert it. It fits snugly over the ventilation slits 4 . The
ventilation grille can now be reattached. Carefully press it into the clips
until it locks entirely in place. Never operate your Thermomix
ventilation grille 5 . Check the protection grids for stains every time you
clean your Thermomix from the outside.
®
1
4
52

Changing the protection grid

without the
®
2
5

Changing the protection grid on the bottom

To install the protection grid on the bottom of the Thermomix
the Thermomix ® from the mains power supply. Remove the mixing bowl and
tilt the Thermomix as shown 6 . Take the protection grid for the bottom 7 .
®
It has an oval bump that must face the bottom of the Thermomix
Lay the protection grid under the upper ridges, then press down until you hear
that the grid has locked in place 9 .
To remove the protection grid, disconnect the Thermomix
power supply first. Remove the mixing bowl and tilt the Thermomix
the same way as when you inserted the grid. There is a tab at the left of the
protection grid. Pull on this to remove the protection grid.
3
, disconnect
®
8 .
®
® from the mains
in
®
6 7
9
8
Changing the protection grid 53