Warranty ................................4 Product description ............................4 ShowTex NV and its employees are fully aware of their task to provide a reliable edition Safety instructions ............................. 4 of this document. Nevertheless they can accept no liability for (the direct or indirect Technical specifications ...........................
Make sure the reveal cloth is always visible to the operator of the system. Do not allow any item the be revealed when in doubt about the safety or ShowTex warrants that its mechanical/technical products, when delivered in new good working order of the system. Most accidents are the result of lack of condition, in original packaging, sold directly and used in normal conditions, are free training, carelessness and overconfidence, do not assume anything.
TECHNICAL SPECIFICATIONS The following components are part of the AutoReveal 600 system. 3. LINK CABLE CAUTION! The components included in your shipment will depend on the specific Art. No. Colour Weight Length situation in which you want to use this system.
SETUP A: THE REVEAL SYSTEM IS PLACED UNDER THE OBJECT OR STAGE SETUP B: THE REVEAL SYSTEM IS PLACED BEHIND THE OBJECT THE DIFFERENCE BETWEEN BOTH SETUPS IS THE ROLLING DIRECTION OF THE MOTOR AS SHOWN BY THE PICTURES BELOW. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
1: Use the remote control to test & operate your reveal system. 2: Lift (or lower) the roller and secure the bolts on both sides of the case. 2: Turn anticlockwise to roll up and clockwise to unroll. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
1: Use the switches on the left-hand side of the motor to install the limit switches. An arrow indicates the rotating direction of the roller. Make sure both switches are set to 0. 2: Keep the curtain 0.5m out of the case, set the corresponding limit switch to 1. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
1: Use the remote control to unveil your new product! 2: Keep the curtain straight and tightly tensioned during this movement. 2: Make sure you leave enough time between the last rehearsal & the show. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
1: Open the front cover and turn the roller with hook fastener facing upwards. 2: Connect the remote control to a power supply. 2: Attach the reveal curtain to the roller using the hook & loop fastener system. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
1: Roll up the curtain 1.5 turn by operating the remote control. 1: Place the top cover back on the flightcase. 2: Unroll the curtain 0.5 turn and set the corresponding limit switch to 1. 2: Fasten the butterfly locks to secure. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
1: Unroll the curtain whilst keeping it straight and tightly tensioned . 1: Use the remote control to test your reveal system. 2: Make sure you leave enough time between the last rehearsal & the show. SHOWTEX INSTALLATION MANUAL AUTOREVEAL 600...
CONTACT & SUPPORT THE MOTOR DOES NOT TURN IN BOTH DIRECTIONS For more technical assistance, please contact your local ShowTex branch, the If used too frequently, the engine will overheat. This is protected by a address...
Need help?
Do you have a question about the autoreveal 600 and is the answer not in the manual?
Questions and answers