Module Programming - golmar Nexa Installation Manual

8
To enter programming mode, press the key button three times and then enter secret administrator code
"271800".
To exit programming mode, press the C button (cancel) once if it is in a programming field or twice if
not.
If, after 2 minutes, no key has been pressed, it exits programming mode.
Programming mode entry and exit is confirmed by the emitting of 5
* ( )
Important:
Bear in mind the number of digits in the configured code (factory setting 2718 = 4).
Programming of the keypad functions is performed by entering the field or function code,
followed by the field value(s).
Once in programming mode, the programming sequence is as follows:
0
4
1
ó
If an incorrect value has been entered, press the C button (cancel). The keypad will emit a long
confirmation beep. If the field code was being entered, even after the confirmation beep, exit
this menu and re-enter the field code.
Field
2
4
C
* ( )
key button + key + key + administrator code.
Enter the field code: this code is always 1 digit. The keypad will emit 2
quick confirmation beeps.
Enter the value of the field being programmed. Once the value has been
entered, the keypad will emit 2 quick confirmation beeps. To finish
programming the field, press the key button and the keypad will emit 4
quick confirmation beeps.
Note: If, after 15 seconds, no key has been pressed, a long error beep
will be emitted and the field code will need to be re-entered.
Enter the code of the following field or press the C button (cancel) to exit
C
programming mode.
Field value
2 2
1
C C C

MODULE PROGRAMMING

P
rogramming mode entry and exit.
2 7 1
quick
P
rogramming mode structure and sequence.
Field value Field value
2
0
C C
* ( )
8
beeps.
Finish
2
03
C
4