golmar Nexa Installation Manual page 18

MODULE PROGRAMMING
Continued from previous page
Field "8": Configuring depth of field
Allows the number of digits in the calling code to be configured.
IMPORTANT: This programming field is
Steps: Field + number of calling code digits + direct call
(Step 1)
1
(Step 2)
or
(Step 3)
(Step 4)
(Step 5)
Field "9": Configuring the keypad sound.
Allows a beep to be heard when pressing the access control module's keypad buttons.
(Step 1)
(Step 2)
(Step 3)
(Step 4)
(Not configuring
1
8 or
Press "8" to select field "8".
8
Set the number of digits in the calling code.
2 3
or
Enter one of the following options:
"1" or "2" or "3"
Set the direct call: by entering a call code on the keypad if necessary
0 1
or
or do not press the key button to confirm.
Enter one of the following options:
"0" : Disable.
"1" : Enable.
Press the key button to finish programming the field.
Then press the number of the next field to configure or press the C
9 C
or
button (cancel) to exit programming mode.
Steps: Field + keypad sound + key button.
9
Press "9" to select field "9".
9
Allows a beep to be heard when pressing the access control
0 1
or
module's keypad buttons.
Enter one of the following options:
"0" : No keypad sound.
"1" : Keypad sound.
Press the key button to finish programming the field.
Then press the C button (cancel) to exit programming mode.
C
).
not applicable for standalone access control.
2 3 0
or
0 1
or
P
rogramming mode fields.
+ key button.
1
or
17