step 3. Press tray handle on Sliding the tray with hard drive into the enclosure
step 4. Connecting the cable of LCD Module to ARS5050
Configure RAID Subsystems
3.
step 5. Mounting RAID Subsystem in system
step 6. Connecting RAID Subsystem power
step 7. Connecting RAID Subsystem to Host channel (SATA/Esata/USB2.0)
You can configure RAID Subsystem either through the LCD configuration utility or –
UTran RAID manager utility
3.1 Configuration methods
3.1.1 Using LCD Module(LCM)
The LCM is the primary user interface for the RAID subsystem, All configuration and
management of the controller and it's properly connected disk arrays can be performed
from this interface.
The quick RAID setup flow chat is showed as following:
9