Poulan Pro 437139 Owner's Manual page 9

GAS O LINE
FILLER CAP
MUF FLER
CHOKE
CON-
TROL
PRIM ER
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Choke control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
OPERATION
ELECTRIC
START BUTTON
RECOIL
(AUXILIARY)
STARTER
HANDLE
DE FLEC TOR
DISCHARGE
CHUTE
CLEAN-OUT TOOL
FIG. 10
9
DISCHARGE CHUTE CONTROL LEVER
AUGER
CONTROL
LEVER
DRIVE SPEED
CON TROL LEVER
CHUTE
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-
pro pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di rec-
tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground
Deflector remote control lever - used to change the
dis tance the snow is thrown.
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LIGHT
HANDLE
KNOB
MUF FLER
TOOLBOX
SKID PLATE