Samsung DVD-VR320/XEF Manual page 178

Maximum Recording Time -
Tape Length
E180
E240
E280
E300
When you watch or record on the VCR
during DVD Recording, some function buttons
Note
may not operate.
The message "This function is not available."
will be displayed.
Press the (REC) button on the remote control or
4
front panel.
For options while recording is in progress, see
"Special Recording Features".
Press the STOP button to stop or finish a record-
5
ing in progress.
Pausing / Resuming
• Press the REC PAUSE button to pause a recording
in progress.
• Press the REC PAUSE button again during pause to
resume recording.
• You can switch channels by pressing the
PROG/TRK (
Check Remaining Time
Press INFO. button on the remote control.
1
Following information will be displayed.
(Current deck status, recording speed, remaining
time, input channel, current time.)
RAM
STOP
0:00:02
SP
Rem 06:07
AV 2
Sat 22 Jan. 2005
64 - English
Samsung Electronics
SP vs. LP
Recording Time(in SP)
180 mins or 3 hours
240 mins or 4 hours and 40mins
280 mins or 4 hours
300 mins or 5 hours
) buttons while recording pauses.
/
VCR
STOP
- 0:00:03
SP
Rem 05:41
PR 1
14 : 01
Special Recording
Features
While a recording is in progress, you can watch a differ-
ent channel, watch a different media, or add recording
time in 30-minute increments.
1
Watch a Different Channel
Press the TV/VCR button on the remote to switch
to your TV tuner, then select a different channel on
your television.
2
Watch a different media during recording
You can watch a DVD during VCR recording or
watch a Video tape during DVD recording.
• During VCR recording, insert a DVD in the DVD
deck. The output will automatically change to the
DVD and start playback.
• During DVD recording, insert a Video tape in the
VCR deck. The output will automatically change
to the VCR and start playback. (Only if tape is
missing the safety tab)
3
Add Recording Time
Refer to the One-Touch Recording (OTR).
4
Recording DVD and VCR at the same time
You can record DVD and VCR at the same time,
but both modes must be set up to record separately.
• Press the DVD/VCR button to set the unit to DVD
or VCR mode.
• Choose AV input mode (PR, AV 1, AV 2,
DV). for DVD or VCR.
• Choose REC mode for DVD or VCR.
• Press REC button for DVD or VCR.
When DVD Recorder & VCR is connected to
your TV using S-Video or component video
Note
cable, the playback screen on the video tape
will not display during DVD recording.
You cannot record different channels at the
same time.
The DVD and VCR cannot start recording at
the exact same time. You must set one mode
to start recording, then the other.
Operating Instructions
Aux or
13-53