Peavey VYPYR PRO Operating Manual page 9

Tips for Creating & Editing Presets
•The different types of models are color coded. Amps are red, Instruments (M1 bay only) are yellow, stomp
boxes are orange and effects are blue.
•If there is already a model present, you can change either the type of currently chosen model or you can
change the overall type of model. For instance, if there is already an amp present, to change the type of amp
model, simply turn the dial to select a different amp and press the model encoder. To change the type of model,
push and release the MODE SELECT button, which changes the 4 model screens to MODEL TYPE SELECT
MODE.
•If there isn't a model type present, there is no need to press the MODE SELECT button. Simply turning the
model encoder will automatically change the model screens to MODEL TYPE SELECT MODE.
•If a change in the order of the models is desired, press and hold the MODE SELECT button. The master LCD
screen will read "MODEL 1-4 SWAP MODEL POSITIONS". In this mode, turning any of the 4 model encoders
will move that model back and forth within the preset order. For example, if there are 3 models chosen and the
M4 position is empty and you wish to add a new effect at the beginning of the signal chain, such as a compressor,
you would press and hold the MODEL SELECT button and use the 4th model bay's encoder to move the empty
bay over to bay 1.
NOTE: ANY TIME A STOMPBOX OR AMP IS PRESENT, IT REPRESENTS A NEW PARALLEL SIGNAL
CHAIN. FOR EXAMPLE, IF THE MODEL BAYS ARE STOMPBOX>AMP>STOMPBOX>AMP, AND THE
AMP IN BAY 2 IS BYPASSED, THEN YOU WILL NOT HEAR THE STOMPBOX IN BAY 1 BECAUSE THE
AMP THAT IT FEEDS IS TURNED OFF. SOME TRIAL AND ERROR WILL BE NECESSARY TO GET THE
HANG OF HOW THE SIGNAL CHAIN WORKS IN THE VYPYR PRO.
•To edit each model's parameters, including amp models, press and release the cooresponding model's encoder
(NOTE: pressing and holding the model encoders will bypass that model. This is shown on the model screen as
lower case letters). When the model is chosen, the corresponding screen is brighter, and the parameter encoders
can be turned to change the desired parameters. Anytime a parameter is tweaked, the master LCD screen will
show the name of the parameter as well as the value.
•VERY IMPORTANT. With the Vypyr, delay and reverb are always available, they do not need to be chosen as
a stomp or effect model as is the case with other modeling amps. To change the settings to the delay and reverb,
including turning them off, press and release the DEL/REV EDIT button which is righ next to the TAP TEMPO
button. This will change the mode of the amp to QUICK EDIT DELAY/REVERB mode. In this mode, the 5
parameter encoder's functions change from the top line of text to the bottom line of text. Turning the param-
eter encoders will change the Delay Level, Time Shift (delay times are set using the tap tempo button), Delay
Feedback, Reverb Room Size and Reverb Level. To turn off the delay or reverb, simply adjust the Delay Level or
Reverb Level down to 0.