Midea MPF08CR71 User Manual page 11

Other Features
FOLLOW ME/TEMP SENSING
Feature (optional)
NOTE
This feature can be activated from the remote control ONLY. The remote control
serves as a remote thermostat allowing for the precise temperature control at its
location.
To activate the Follow Me/Temp Sensing feature, point the remote control towards
the unit and press the Follow Me/Temp Sensing button. The remote display is actual
temperature at its location. The remote control will send this signal to the air conditioner
every 3 minutes interval until press the Follow Me/Temp Sensing button again. If the unit
does not receive the Follow Me/Temp Sensing signal during any 7 minutes interval, the
unit will beep to indicate the Follow Me/Temp Sensing mode has ended.
AUTO-RESTART
If the unit breaks off unexpectedly due to the power cut, it will restart with the previous
function setting automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted operation in the first 3 minutes. This is
to protect the unit. Operation will automatically start after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the air flow direction automatically.
NOTE
On some models the louver can be adjusted manually only):
• When the Power is ON, the louver opens fully.
• Press the SWING button on the panel or remote controller to initiate the Auto
swing feature. The louver willl swing up and down automatically.
• Please do not adjust the louver manually.
Remove
the upper
drain plug
Continuous
drain hose
 Page 10 
Water drainage
• During dehumidifying modes, remove the upper
drain plug from the back of the unit, install the drain
connector (5/8" universal female mender) with 3/4"
hose (locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area in
your basement floor.