Advertisement
1.
Make sure the power switch is at OFF position. Load the batteries into
the battery compartment according to the polarities indicated. Load a
set of 12 (recommended), 8 or 4 (emergency, left 2 columns) batteries.
Or connect 6 V external power supply to the camera by using the
correct cable and external battery.
The following batteries can be used:
•
High-performance alkaline batteries
•
Lithium batteries
•
Rechargeable Ni-MH batteries
2.
Insert a SD card (32GB or smaller). Open the camera and insert the SD
card into the card slot. Refer to the card symbol on the case for proper
orientation. The camera supports up to 32 GB SD card. Please note that
the SD-card should not be locked.
3.
Insert a SIM card.
4.
Screw the antenna onto the antenna jack on the top of the camera.
Make sure it's all the way in but DO NOT over tight it.
5.
Slide the power switch to the SETUP position. The camera will enter the
live preview mode and start searching the network.
6.
Wait until the camera finds the network. If the wireless carrier is not
found, you will need to go to the Advanced Wireless Setup section on
Page 10. If the wireless carrier is found, please go to the next step.
Quick Start
4
Advertisement
