Daikin BYCQ140D7GW1 Installation Manual page 8

(6) Remove the EL. COMP. BOX lid from the indoor unit.
Refer to "5-2 Attaching harness (accessory (4))" on page 4.
(7) Connect the swing lead wire connector to the PCB.
X9A
1 PCB
2 Connect the swing lead wire connector to the PCB
Be sure to connect them securely.
3 Swing lead wire (to X9A)
(8) Attach the EL. COMP. BOX lid in the order opposite to the
procedure in "5-2 Attaching harness (accessory (4))" on
page 4.
(9) Guide the lead wires through the hook.
1
1 Hook
2 Guide the wires through the hook
6-4 Attaching dust box
1
2
3
4
5
6
7
1 Engraved mark on piping side
2
Panel clasp
3 Engraved mark on drain side
4 Panel
5
Fall prevention cord
6 Dust box
7 Mount the dust box with the side where the mark is
engraved faced downward.
Installation manual
7
1
2
3
2
b
a
(1) Hook the fall prevention cord for the dust box to the panel
clasp as shown in the illustration.
1 Clasp
2 Hooked fall prevention cord
3 Panel
4 Fall prevention cord
5 Dust box
(2) Attach the dust box in the order opposite to the procedure in
"4-3 Removal of dust box" on page 3.
Note
Make sure that the fall prevention cord is not caught by the
exhaust opening on the dust box when attaching the dust box.
Otherwise, the dust box may not function normally.
(3) Turn the fixing knobs (in two points) of the dust box and secure
the dust box.
(The front side of the panel is shown
for ease of explanation.)
6-5 Mounting S-shaped pipe (accessory (3))
Mount the dust box side (engraved with A) before mounting the
brush side (engraved with B).
(Mount them so that the engraved characters will be in conformity.)
Brush unit
Make sure that
the engraved
characters are in
conformity with
each other.
Claws
(2 points)
Brush unit 2
Brush unit side
S-shaped pipe
(accessory (3))
Note
Check that the claws are engaged securely. Otherwise, a dust
collection failure may result.
BYCQ140D7GW1 + BYCQ140D7GFW1
1
2
3
4
5
Fixing
knob
Fixing
knob
Dust box
Dust box
Dust box side
Claw
(1 point)
1
Make sure that the
engraved characters
are in conformity with
each other.
Self cleaning decoration panel
4P310441-1C – 2017.05