Usb To Rs422 Driver Installation; For Windows Xp Users - Renkus-Heinz iConyx IC8 Owner's Manual

Owners Manual
INSTALLING THE USB TO RS422 ADAPTER DRIVERS
Normally the USB to RS422 adapter and serial extension cable is installed before any of the soft-
ware programs. However, the USB to RS422 adapter and software programs can be installed in any
order.
The USB to RS422 adapter is required for communications (data transfer) between the Iconyx col-
umn arrays and the Array II and Canvas software programs. The Iconyx Software CD includes the
driver needed to install the USB to RS422 adapter. Before starting the installation make sure the
USB to RS422 converter and serial extension cable is not connected to any of the Iconyx
column arrays.

FOR WINDOWS XP USERS

1. With the PC on and Windows running, insert the Iconyx Software CD into your CD drive. Connect
the USB to RS422 adapter to an available USB1.1 compatible USB port. Windows will prompt you
with the following message. (If you do not receive this message window, skip ahead to page 17 and
the section "If Windows Did Not Prompt To Install Drivers automatically).
Select the option to not search Windows Update by clicking on "No, not this time" and then on Next
to continue.
2. You will be prompted with the following "Found New Hardware Wizard" screen. Select "Install the
software automatically (Recommended)" and click on Next. Windows will find the appropriate driver
automatically.
12