Table of Contents
Advertisement
3.
Rout the audio cable beneath the belt clip as shown to
prevent accidental disconnection of cable
4.
For notebook and desktop computer connections, connect the
1/8" stereo male end of the cable to the headphone jack located
on your electronic device.
For stereo systems connection, connect the two RCA male ends of
the cable to the left and right outputs located on the back panel of the
electronic device.
5.
First turn ON the receiver dongle by pressing and holding the
v
POWER button
on the receiver dongle for 2 seconds.
F
The Power Status LED on the receiver (Rx) will show Solid Green LEDs
F
The flashing Green LED on the transmitter (Tx) will turn to Solid
Green indicating communications between (Tx) and (Rx) is established.
6.
Place the receiver dongle on top of the stereo system or next to your computer.
7.
Power up your stereo system or computer and are you are ready to go!
RECEIVER CONNECTION
Audio Cable
Belt Clip
(Rx)
Wi-AudioLink
v
33
Advertisement
Table of Contents
