Table of Contents
Advertisement
5.
Verify if you are connecting a passive or active electric guitar to the transmitter. If the electric guitar use a
battery to operate, then the guitar is an active type. If not then the guitar is a passive type.
5.1
For Passive Guitars Connection
a. Power up the transmitter by pressing and holing the POWER button
F
The Power Status LED will show Slow Flashing Blue and Solid Green LEDs
F
The standard factory power up setting is set for Passive Guitars . The transmitter can remember
and power up in the last power up mode selected .To change the startup mode to the desired
mode please refer to the "Tx Function Matrix" of this manual for detailed instructions,
5.1
For Active Guitar & Electric Acoustic Instruments Connection
a. Power up the transmitter by pressing and holing the POWER button
b. Press and hold the Mode button
F
The Power Status LED will show Slow Flashing Blue and Solid Green LEDs
6.
Attache the Wi-AudioLink to the optional Wi-Guitar Strap or to your belt.
F
Please proceed to page 28 for the receiver connection
r
for 2 seconds. The Blue LED will display fast flashes
TRANSMITTER CONNECTION
k
for 2 seconds.
k
for 2 seconds.
Wi-AudioLink
r
k
(Tx)
21
Advertisement
Table of Contents
