Table of Contents
Advertisement
Status
System status information can be read using the status module If you contact SDi
for technical support, you may be asked to provide some of the information displayed
here (such as the firmware version and hardware revision). The status app is not used
to make changes to the system.
Accessing saved measurements from a PC
When you connect the VOX-01 to the USB port of a PC or Mac, a dialog window will appear
on the VOX-01 asking if you wish to start data transfer. If the VOX-01 is powered off when you
connect it through USB, it will power on automatically.
The VOX-01 will present itself to the USB host as a mass storage device. This allows you to
access the internal file system of the VOX-01. You will see these directories/folders:
•
Battery: battery status information
•
Calibr: Calibration data
•
SPL: SPL measurement results
•
STIPA: STIPA measurement results
•
System: system files
•
Update: place update packages here to update the firmware upon reboot
IMPORTANT: you can access the VOX-01 system files so that you can
easily backup and restore the device. However, keep in mind that some of the
internal software of the VOX-01 is run directly from the files displayed here. If
you remove or change any of these files, your VOX-01 will not work properly
anymore.
Instructions on how to perform firmware updates is given in the section 8 of this manual.
In order to process and analyze the results further, copy all results files from the VOX-01 to
a local folder on your PC. If you leave the measurements on the VOX-01, then the VOX-01
will simply continue its measurement numbering series where it left off. If you remove the
measurements, the VOX-01 will start over with measurement #1.
The measurement files are saved in .csv format. These files can be imported in almost all
worksheet application, such as Microsoft Excel. This will allow you to analyse the data
further, and pre-process the data for the purpose of reporting.
36
VOX-01 Operating Manual
Advertisement
Table of Contents
