Table of Contents
Advertisement
By pressing the "save" (
measurement on the devices internal storage, using the measurement number indicated
above the battery indicator.
Some remarks about the RTA module:
•
By definition, "max hold" and "EQ" are mutually exclusive settings.
•
The elapsed measurement time is shown above the progress bar. If the
measurement interval is set to "continuous," the measurement will run un-
til it is manually stopped. The progress bar itself is not used when measur-
ing continuously.
•
Measurements saved as 1/1 octave cannot be retrieved as 1/3 or vice versa.
However, data recalled through the measurement browser are shown with
the frequency weightings selected at the time the measurement is recalled
- even if these are different from the settings that were in effect during the
measurement. This allows you to inspect the effect of frequency weightings
on all measurements saved previously
•
Note that the spectrum and its corresponding broadband level are affected
by the same time- and frequency weightings. In other words, if the main
spectrum is A-weighted, then the level shown in the red field is also A-
weighed (and vice versa). If you wish to display a Z-weighted spectrum and
an A-weighted level at the same time, you need to display these in different
channels (main and aux).
•
The measurement numbers form a separate consecutive series for each
module. That means that the same measurement number might occur
multiple times (once for each module; e.g. number #0002 might exist for
SPL as well as RTA, STIPA, etc.)
) button in the main measurement screen, you store the current
VOX-01 Operating Manual
17
Advertisement
Table of Contents
