Adjusting Poly V-Belt Tension; Operation - Terratek TBS250 User Manual

9) Place the new belt (A) partially around the motor pulley (E) to get it started, then turn the
wheel (C) by hand until the belt (A) is completely seated on the motor pulley (E).
10) Push the motor down to add tension to the belt (A).
The belt is properly tensioned when moderate finger pressure on the belt between the two
pulleys causes about 1/2" deflection.
11) Tighten the hex cap screw on the back of the cabinet that secures the motor.
Re-install the blade.

Adjusting Poly V-Belt Tension

Disconnect machine from the power source! Never make adjustments with the machine running!
Failure to comply may cause serious injury!
1) With a 13mm wrench, loosen the hex screw on the back of the cabinet that secures the motor.
2) Push the motor down to add tension to the belt (C).
The belt is properly tensioned when moderate finger pressure on the belt between the two
pulleys causes a 1/2" deflection.
3) Tighten the hex screw that secures the motor.

Operation

On/Off Switch
Ensure that the switch is in the "OFF" position. If the plug is connected to a receptacle while
the switch is in the "ON" position, the power tool will start operating immediately and can cause
serious injury.
On/Off Switch – located on front of machine: pull switch out to start; push switch in to stop.
Whenyellow safety key is removed, machine will not start.
Work Lamp Switch – located on front of machine above On/Off switch. Turns LED work lamp on
and off.
Making cuts
1) Adjust the bevel angle, rip fence, mitre gauge and upper blade guide.
2) Make sure the table insert is in place and flush with the table.
3) Start the saw by pulling switch out to start.
4) Start the cut by pushing the wood into the moving saw blade.
5) Do not force the cut, use only enough pressure to keep the saw cutting, let the blade do the
work.
6) If cutting round material use a jig or fixture to keep the material from turning.
7) When you are finished remove the yellow safety key to prevent unauthorized use.
ACL Group (Intl) Ltd
25
Email: eusales@terratekintl.com www.terratekintl.com