TP-Link JetStream T1500-28TC Installation Manual page 8

JetStream Smart Switch
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each has a corresponding 1000M LED.
SFP Port
Designed to install the SFP module. T1500-28PCT features some SFP transceiver
slots that are shared with the associated RJ45 ports. The associated two ports
are referred as a "Combo" port, which means they cannot be used simultaneously,
otherwise only SFP port works. Meanwhile, the associated two ports share the same
LED. For T1500-28PCT, Port 27 shares the same LED with Port 27F and Port 28
shares the same LED with Port 28F.
Rear Panel
■
The rear panel of T1500-28TC is shown as the following figure.
Figure 1-3
Kensington Security Slot
The rear panel of T1500-28PCT is shown as the following figure.
Figure 1-4
Kensington Security Slot
Kensington Security Slot
Secure the lock (not provided) into the security slot to prevent the device from being
stolen.
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC (Alternating Current) power outlet. Please make sure the voltage of the power
supply meets the requirement of the input voltage.
Grounding Terminal
The switch already comes with lightning protection mechanism. You can also ground
the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
For detailed information, please refer to Chapter 3 Lightning Protection.
Caution: Please use the provided power cord.
05 Introduction
Rear Panel of T1500-28TC
Rear Panel of T1500-28PCT
100-240V~ 50/60Hz 0.3A
Grounding Terminal Power Socket
100-240V~ 50/60Hz 3.0A
Power Socket Grounding Terminal