Landmarks - Nokia E66 User Manual

The trip meter has limited accuracy, and rounding
errors may occur. Accuracy can also be affected by
availability and quality of GPS signals.
Use GPS data
To check the signal strength of the satellites that
provide the positioning information necessary for
navigation, open any of the three views and select
Options Satellite status.
>
To set a landmark or location as the destination of your
trip, select Navigation Options Set
> >
destination. You can also enter the destination
latitude and longitude coordinates.
To remove the destination set for your trip, select
Navigation Options Stop navigation.
> >
To save your current position as a landmark, select
Navigation or Position, and Options Save
>
position.
To activate the trip meter, select Trip distance
Options > Start. To stop the trip meter, select
Options > Stop.
To reset all fields and start calculating the trip again,
select Trip distance Options > Restart.
>
To change the measuring system in use, select
Options Settings Measurement system
> >
Metric or Imperial.
To enter the altitude calibration to correct the altitude
received from the positioning satellites, select
Options Settings Altitude calibration.
> >
Cyan Cyan Cyan Cyan Magenta Magenta Magenta Magenta

Landmarks

Select Menu GPS > Landmarks.
>
Landmarks are coordinates to geographic locations
that you can save to your device for later use in
different location-based services. You can create
landmarks using the internal GPS receiver of your
device or network (network service).
Create a landmark
To create a landmark, select Options
landmark. Select Current position
request for the latitude and longitude coordinates of
your current location, Use map to select the location
from a map, or Enter manually to fill in necessary
location information such as a name, category,
address, latitude, longitude, and altitude.
To show the landmark on the map, select
Show on map.
>
>
Yellow Yellow Yellow Yellow Black Black Black Black
New
>
to make a network
Options
>
65