Service Menu - Hitachi PJ-TX10 Service Manual

SERVICE MENU

SERVICE MENU
C10H
FANSPEED
B-SPEED
DURABLE
VIDEO NR
LENS
FILTER TIME
MUTE COLOR
AIR-SENSOR
Setup of a Cooling Fan Speed
When using this projector in the place where altitude is high, we recommend you to set a cooling fan's speed as
"HIGH". It is because the cooling effi ciency of a projector falls and the temperature inside a projector rises easily
in such a place, since the density of air becomes low.
Setting Method of Cooling Fan Speed
1. Select the "FAN SPEED" on the OSD using button " ".
Next press the " " to select "FAN SPEED MENU" by the SERVICE MENU.
SERVICE MENU
FANSPEED
HIGH
NORMAL
2. Select the "HIGH" on the OSD using the button "
button " ".
3. The OSD will be ended by no operation for 10 seconds or change of input signal. To end immediately, use
one of buttons except buttons " ", "
NOTE:
The "HIGH" mode makes the fan noisy than "NORMAL" mode.
The recall of factory setting sets the fan speed to "NORMAL" mode. You must set the fan speed after recall of
factory setting if you need "HIGH" mode.
PJ-TX10 (C10H)
To display the OSD for "SERVICE MENU" set up.
By the control panel
1. Display the menu by the "MENU"
button.
2. Select the "OPTION" on the menu.
3. Continue press the button " " fi rst,
then press the button " " together
with "INPUT", and hold for 3 seconds.
", " ", " ".
By the remote control transmitter
1. Display the menu by the "MENU"
button.
2. Select the "OPTION" on the menu.
3. Press the "ON" button.
Next hold the "ON" button for 3
seconds.
". To reset this setup, select the "NORMAL" using the
27