Important Information - Krups EA89 Series Manual

Espresso automatic

Manual (56 pages)

Manual (306 pages)

Manual (306 pages)

Table of Contents

filled. To do this, follow the instructions provided on the screen. The machine will begin by filling the water circuits,

preheating the circuits and then will complete an automatic rinse.

The screen will inform you when installation is complete.

Water hardness

You must set your machine depending on the hardness of your water, from 0 to 4. To do this, follow these instructions:

Before using the appliance for the first time, check the hardness of your water so that you can set the appliance

accordingly. This operation should also be carried out when you use your machine in a place where the hardness of

the water is different or if you notice a difference in the hardness of the water. To check the water hardness, use the

test strip supplied with your machine or contact your local water authority.

The details of the classes are given in the table below:

Degree of hardness

° dH

° e

° f

Appliance setting

Fill a glass of water and insert a strip. Fig. 2

After 1 minute read the level of water hardness. Fig. 3

Indicate the number of red zones when configuring the appliance.

Preparing the appliance

Remove and fill the water tank. Fig. 7.

Replace the water tank. Fig. 8.

Remove the lid of the coffee bean container and add coffee beans (max. 250 g). Fig. 9.

Replace the lid of the coffee bean container. Fig. 10.

Depending on the drinks chosen, your Espresso Automatic EA89 will automatically adjust the quantity of ground coffee.

Preparing the grinder

You can adjust the strength of your coffee by adjusting how finely the coffee beans are ground. In general, the finer the

coffee is ground, the stronger and creamier the coffee will be. It may also vary according to the type of coffee used. We

recommend a fine setting for espressos and a coarser setting for coffees.

Adjust the fineness of grinding by turning the coffee grounds fineness adjustment knob (J) which is located in the coffee

bean container. This setting should be applied during grinding notch by notch. After 3 rounds, you will notice a

pronounced difference in taste.

Setting the fineness of grinding is useful when you change the type of coffee or if you want to make coffee that is more

or less strong. However, it is not advised to use this setting systematically.

Adjusting the coffee outlet

For all the drinks available, you can lower or raise the coffee outlets according to the size of your cup or glass. Fig.11

Stopping a drink during preparation

You can stop the preparation at any time by pressing the return button

Caution, pressing this button causes the machine to update which may last up to 30 seconds. This phase is normal.

When a cycle is interrupted, it does not stop immediately. The machine will finish its cycle and the preparation will be

cancelled.

"Double" preparation function

You can prepare two cups simultaneously with your appliance. The double preparation function can be accessed simply

by pressing the selection twice and is valid for all drinks (except

Class 0

Class 1

Very soft

Soft

< 3°

> 4°

< 3,75°

> 5°

< 5,4°

> 7,2°

BEFORE PREPARING DRINKS