BlueTrek BT01 User Manual page 5

4. Pairing Bluetrek® headset to a Bluetooth mobile phone
Before using the BlueTrek® Headset, you must pair it with your BlueTooth mobile phone.
Pairing is the process of linking two BlueTooth devices, so that they can communicate.
The pairing only needs to be done once. Afterwards, every time you switch on your Headset, it
will automatically connect to your mobile phone. If you pair your Bluetooth mobile phone with
another Bluetooth device, you will have to pair the Bluetrek® Headset with your phone again
before use.
IMPORTANT: before pairing, all Bluetooth devices have to be switched off.
To initiate a pairing, put both the Headset and the mobile phone within 1 meter (3 feet) from
each other.
1- Switch on your phone and select the BlueTooth discover mode (or sniff mode) on
the Mobile Phone (See the BlueTooth Mobile Phone user's manual)
2- Press the ON button (See Button 1 on Figure 1) on the Headset and keep it pressed
for about 8 seconds.
(Remark: After 3 seconds, the light with flash green and red and you will hear a
music tone in the speaker; Do not release the button at that time! Only after 8
seconds, when the light flashes only in red and you can hear a lighter tone, can you
release the button).
3- Once the mobile phone detects the headset, a message is displayed with the
following information: Bluetrek 01.
4- Follow the phone instructions to accept the Pairing; PIN code (or passkey) is 0000.
5- When the pairing has been completed, the light switches from red to green, and
flashes slowly.
Now you can make calls and receive calls from your BlueTrek® headset.
Example: How to pair your headset with the Sony Ericsson T68i.
1. Take your Sony Ericsson T68i and go to the main menu. From there select the
"CONNECT" option
2. Select option 3, "Bluetooth"
3. Select option 2, "Paired devices" and if you had previously paired your phone with
another headset, you will see it in the list. To cancel a pairing, highlight the device and
press on "C" to delete it.
4. Switch off completely your headset by pressing simultaneously button 1 and button 2
until you hear a music tone.
5. Press button 1 and keep your finger pressed: the headset will be switched on
6. Keeps on pressing button 1 until you hear a second music tone and you see a red light
flashing quickly. You can now release button 1.
7. From your T68i, go back to the previous screen and select option 3, "Discover": The
T68i is now searching for the Bluetrek.
8. Once it has found it, press the "Yes" key to confirm it.
9. Press again the "Yes" key to confirm the option 1: "Add to paired"
10. Type your passkey: 0000 (four zeros) and then press "Yes"
11. The pairing is then in process and you should read under the title Nametag: BlueTrek 1.
12. Press "Yes" to confirm again.
13. Your mobile phone is now paired and ready to use.