Aux Audio Inputs And Levels; On-Screen Display Function Menu; Aux Audio Input And Level - Datavideo AD-200 Main Unit Instruction Manual

AUX Audio Inputs and Levels

There are two types of switches for configuring AUDIO IN:
The LINE/MIC+40dB/MIC+60dB switch is used to set the AUDIO IN to LINE IN, MIC+40dB IN or MIC+60dB IN.
When LINE IN is selected, set the 48V switch to OFF in order to prevent damage to the circuit due to excessive
current flow.
The 48V switch is
LINE/MIC+40dB/MIC+60dB switch to MIC IN. Turn the 48V switch to ON if a condenser microphone is used. Turn
the 48V switch to OFF if a dynamic microphone is used.
*NOTE: Always check the manual for the appropriate microphone and read the advice in the manual
regarding phantom power as some MICs have internal batteries too.

On-Screen Display Function Menu

1. MIXER I/O Configuration
The mixer has six input channels, which are mixed in different combinations. The mixed audio is subsequently sent to
the output channel. In the example illustrated below, the mixer setting is configured by enabling the desired audio
input channels and feeding the enabled combination to the corresponding output channel.
Description of the above configuration example:
Out1 is audio input CH1 only.
Out2 is audio input CH1~6 mixed.
Out3 is audio input CH2 only.
Out4 is tone mixed.
CH1
1
designed specifically
CH2 CH4
CH3
2
Group 1
for phantom power
+ : Enable
- : Disable
1~6 : Audio Input (CH1~6)
T : Tone
OUT1~4 : Audio Output (CH1~4)
CH5
CH6
3 4
Group 2
- 10 -
control. To use MIC
T
Audio IN
Audio OUT
IN, set the