Assembly - Poulan Pro 193747 Operator's Manual

CAUTION: Do not operate this mower
without the discharge guard or an entire
approved grass catcher in place. These
guards are for your protection and are re-
quired by the American National Standards
Institute and Consumer Products Safety
Commission.
CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
ASSEMBLE LOWER HANDLE
(USE HARDWARE GROUP "A")
MODELS WITH BOLT-ON LOWER
HANDLE:
• For ease of lower handle assembly, raise
rear of deck and block se cure ly.
• Position lower handle on deck as shown:
- (20" mowers) cut-off fl at forward.
- (22" mowers) arrow down.
• Align holes in handle with holes in deck
as shown and assemble 3/8-16 x 3/4
hex bolts, 7/8" washers and fl anged
lock nuts. Tighten securely.
• Repeat for opposite side of mower.
Lower 7/8" Washers
handle
Arrow
down
(22"
Mowers)
Cut-off fl at forward
Hex bolts
MODELS WITH DECK HANDLE
BRACKETS:
• Install lower handle onto handle brack ets
by squeezing the bottom ends of handle
towards each other until the handle
will slip onto the mounting pins on the
handle brackets.
• Pull handle back to lock in operating
position.
• Install the two (2) hairpin cotters sup-
plied onto the mount ing pins.

ASSEMBLY

Flanged locknuts
(20" Mowers)
9
SQUEEZE
TO INSTALL
Lower handle
Handle bracket
Hairpin cotter
(REAR DISCHARGE MOWER SHOWN)
ASSEMBLE UPPER HAN DLE
(USE HARDWARE GROUP "B")
MODELS WITH NON-FOLD ING HANDLES:
• Position upper handle over lower handle:
- (20" mowers) small hole for mount ing
upstop brack et to left hand side.
- (22" mowers) side of handle with four
(4) holes as shown to left hand side.
• Assemble 1/4-20 x 1-1/2 hex bolts and
1/4-20 locknuts. Tighten se cure ly.
Four (4) holes
(22" Mowers)
Hex
bolts
Locknuts
MODELS with FOLDING UPPER HANDLE:
• Position upper handle over lower handle
with small hole for mounting upstop
bracket to left hand side.
• Assemble handle bolts and wing nuts.
Tighten se cure ly.
Upstop
bracket
Upstop
bracket screw
#10-24 x 1/2
mounting pin
Upstop
bracket
Upstop bracket
screw #10-24 x 1/2
Wing nuts
Handle bolts