Poulan Pro 193747 Operator's Manual page 14

ASSEMBLE CABLE(S) TO
UPPER HANDLE
(USE HARDWARE GROUP "F")
• Assemble cable(s) to opposite side of
upstop bracket.
• Be sure to route cable(s) underneath
crossbar of lower handle.
• Position throttle control (if equipped)
on outside of handle and zone control
square fi tting on the inside.
• Secure to handle with the 1/4-20 ma-
chine screw or hex bolt supplied and
lock nut (if required) as shown. Tighten
se cure ly.
• Secure cable(s) to crossbar and low er
handle with cable tie(s) as needed.
MODELS WITH REMOTE THROTTLE:
Control bar
Throttle
control
Machine
screw
Engine zone
control cable
square fi tting
MODELS W/O REMOTE THROTTLE:
Control bar
Screw
Engine zone
control cable
Wire tie
ASSEMBLE ROPE GUIDE
(USE HARDWARE GROUP "G")
• Put threaded end of rope guide through
hole in side of upper handle above lower
handle crossbar. Se cure with 1/4-20
keps locknut.
• Hold control bar against upper handle
and slowly pull starter rope out until rope
will slip into loop of rope guide.
Rope
guide
Engine
starter rope
Upstop
SPARK PLUG BOOT (
bracket
(NO HARDWARE REQUIRED)
On some model lawn mowers a spark plug
boot is packed loose in the parts bag. If
Locknut
your model has one, install it on spark plug
wire and then reconnect plug to spark plug.
ASSEMBLE GRASS CATCHER
Wire tie
(REAR DISCHARGE MODELS ONLY)
(NO HARD WARE REQUIRED)
• Put grass catcher frame into grass bag
with rigid part on bottom.
• Slip vinyl bindings over frame. If bind-
ings are too stiff, hold them in warm
Upper
water for a few minutes. Allow bag to
handle
dry before using.
Frame
Up-stop
handle
bracket
Vinyl
bindings
14
Upper
Locknut
handle
Lower
handle
crossbar
IF EQUIPPED
Spark
plug
wire
Boot
Frame
opening
)