Poulan Pro 193747 Operator's Manual page 13

ASSEMBLE ENGINE ZONE
CONTROL CABLE TO
ENGINE
(NO HARDWARE REQUIRED)
Follow the appropriate instructions below for
the brand or type of engine on your mower.
MODELS WITH BRIGGS & STRATTON
CLASSIC OR SPRINT ENGINE
Cable attaches under brake arm cov er, which
is op po site spark plug end of engine.
• Straighten cable and fi nd the end with
the small plastic fi tting.
• Hook the "Z" bend fi tting on inner wire of
cable into hole in brake arm of engine.
• Align the tapered end of the plastic fi tting
with the hole in mounting brack et and
push in until fi tting snaps into place.
• Route cable below crossbar portion of
lower handle and up to upper handle
control bar.
• Hook "Z" bend fi tting on inner wire into
hole in control bar (See "ASSEMBLE
CABLES TO UPPER HANDLE" in this
manual).
Engine Brake arm
cable clip cover
Hex head screw #10 x 5/8
MODELS WITH TECUMSEH ENGINE
• Straighten cable and fi nd the end with
the small ta pered plastic fi tting.
• Hook the "Z" bend fi tting on inner wire of
cable into hole as shown.
• Align the tapered end of the plastic fi tting
with the hole in the mounting bracket
and push in until fi tting snaps into place.
• Route cable under crossbar portion of
lower handle and up to upper handle
control bar.
• Hook "Z" bend fi tting on inner wire into
Small
plastic
fi tting
MODELS WITH BRIGGS & STRATTON
QUANTUM ENGINES
• Hook the "Z" bend fi tting on inner wire
Mounting Brake
bracket arm
• Position the tapered plastic fi tting into
• Route cable under crossbar portion of
• Hook "Z" bend fi tting on inner wire into
"Z" Fitting
Small plastic fi tting
Brake lever (rearward spark plug)
Mounting bracket
(rear ward spark plug)
13
hole in control bar (See "ASSEMBLE
CABLES TO UPPER HANDLE" in this
manual).
of cable (end with tapered plastic fi tting)
into hole in brake lever of engine. Cor-
rect brake lever to use is de ter mined by
position of spark plug on your mower
- forward or rearward.
the mounting brack et on engine. Snap
fi tting into place.
lower handle and up to upper handle
control bar.
hole in control bar (See "ASSEMBLE
CABLES TO UPPER HANDLE").
"Z"
Fitting
Mounting
bracket
Brake lever
(forward spark
plug)
Mounting bracket
(forward spark plug)