Poulan Pro 193732 Operator's Manual page 5

Operator
presence
control bar
LIFT
UP
LIFT
UP
3 POSITION "EZ" HANDLES
• Raise lower handle section to operating
position and align hole in handle with
one of three height positioning holes.
• Insert handle bolt through handle and
bracket and secure with knob.
• Repeat for opposite side of handle.
Knob
3 POSITION "QUICK" HANDLES
• Raise lower handle section to operating
position and squeeze the bottom ends
of lower handle towards each other until
the pin in handle can be inserted into
one of the three height adjustment holes.
SQUEEZE
Handle
ad just ment
bracket
MOWING ALL HANDLES
POSITION
• Raise upper handle section into place on
lower han dle, remove protective padding
and tighten both handle knobs.
• Remove handle padding holding opera-
tor pres ence control bar to upper handle.
• Your lawn mower handle can be ad-
Upper
justed for your mowing comfort. Refer to
handle
"ADJUST HANDLE" in the Service and
Adjustments section of this manual.
NOTE: For shipping purposes, the rear
wheels on your lawn mower may not be
Handle
adjusted to the same position as the front
knob
wheels. Before operating mower adjust all
wheels to the same cutting height.
Lower handle
INSTALL REAR WHEELS
(HIGH WHEEL MOWERS ONLY)
Some high wheel models require wash ers
which will be pro vid ed in a parts bag. If provid-
ed, install washers on the axle fi rst as shown.
• Install one (1) rear wheel on the axle of
rear wheel adjuster.
• Install 3/8-16 locknut and tighten securely.
• Repeat procedure for other rear wheel.
Bolt
Handle
ad just ment
brack et
Flanged
locknut
AS SEM BLE GRASS CATCHER
(REAR DISCHARGE MOWERS ONLY)
Handle pin
IMPORTANT: If your model lawn mower
is mulcher ready, the mulcher plate or plug
must be removed before using mower as
a bagger. To convert mower to bagging or
discharging, see the Operation section in
this manual.
Look at the different grass catcher illustra-
tions that follow. Determine which type
of grass catcher you have and follow the
appropriate instructions.
5
Wheel Axle
assembly
Wave
Washers