Table of Contents
Advertisement
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are properly infl ated (See "PROD-
UCT SPECIFICATIONS" section of this
man u al). If tires are over or underinfl ated,
you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• At the midpoint of both sides of mower,
measure height from bot tom edge of
mower to ground. Distance "A" on both
sides of mower should be the same or
within 1/4" of each other.
• If adjustment is necessary, make adjust-
ment on one side of mower only.
• To raise one side of mower, tighten lift
link ad just ment nut on that side.
• To lower one side of mower, loosen lift
link ad just ment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 1/8".
• Recheck measurements after ad just ing.
Bottom edge
00598
of mower to
ground
A
Ground Line
Lift Link
Adjustment Nut
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to
side. If the following front-to-back ad just -
ment is necessary, be sure to adjust both
front links equally so mower will stay level
side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so
that the front is approximately 1/8" to 1/2"
lower than the rear when the mower is in
its highest position.
Check adjustment on right side of trac-
tor. Measure dis tance "D" directly in front
and behind the mandrel at bottom edge of
mower housing as shown.
• Before making any necessary ad just -
ments, check that both front links are
equal in length.
• If links are not equal in length, adjust
one link to same length as other link.
• To lower front of mower loosen nut "E"
on both front links an equal number of
turns.
• When distance "D" is 1/8" to 1/2"
• To raise front of mower, loos en nut "F"
• When distance "D" is 1/8" to 1/2" lower
• Recheck side-to-side ad just ment.
Bottom edge of
mower to ground
A
Suspension Arm
01553
TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drive belt may be re-
placed without tools. Park the tractor on
level surface. Engage parking brake.
BELT REMOVAL -
1. Remove mower from tractor (See "TO
2. Work belt off both mandrel pulleys and
3. Pull belt away from mower.
BELT INSTALLATION -
1. Work belt around both mandrel pulleys
2. Make sure belt is in all pulley grooves
3. Install mower (See "To Install Mower"
23
lower at front than rear, tighten nuts "F"
against trunnion on both front links.
from trunnion on both front links. Tighten
nut "E" on both front links an equal
number of turns.The two front links must
remain equal in length.
at front than rear, tighten nut "F" against
trun nion on both front links.
"D"
"D"
Both Front Links Should be Equal in Length
Nut "F"
Trunnion
Front Links
REMOVE MOW ER" in this sec tion of
manual).
idler pulleys.
and idler pulleys
and inside all belt guides.
in this section of this manual).
01268
Mandrel
01267
Nut "E"
Advertisement
Table of Contents
