Operating External Devices; Ipod; Connecting Ipod Devices - Hyundai Sonata User Manual

Scanning MP3 file
1. Press the button.
Each press will change the function in the fol-
lowing order : Scan Folder Scan Scan Off
Scan ...
Folder Scan : plays all files in the current
●
folder for 10 seconds each.
Scan: scans all files in the disc for 10 sec-
●
onds each.
Voice Command
1. Press the key on the steering wheel
remote controller.
2. After the beep sound, say a command.
"Scan"
"Folder Scan"
Say "Normal Play" in order to terminate the
set Scan function.
2. Press the button again to continue
listening to the file. The scan will be termi-
nated and the current file will continue to be
played.
PART 2 AUDIO SYSTEM PART 2 AUDIO SYSTEM

Operating external devices

iPod®
iPod ® is a registered trademark of
Apple Inc.

Connecting iPod devices

Connect the iPod device as shown in the pic-
ture.
The Hyundai iPod Power cable is needed in
order to operate iPod with the audio buttons
on the audio system. The USB cable provided
by Apple may cause malfunction and should
not be used for Hyundai vehicles.
The Hyundai iPod Power cable maybe pur-
chased through your Hyundai dealership.
2-24
INFORMATION
When scanning has completed an entire revo-
lution, the scan function is automatically ter-
minated and the previously played file will be
restored.
Unsupported iPod devices : iPod genera-
tions before iPod 3G, iPod Shuffle, and iPad.
CAUTION!
Some functions may not operate properly
depending on the firmware version in some
iPod or iPhone devices.
INFORMATION
In order to prevent such malfunction, check
the following before connecting your iPod or
iPhone device with the Hyundai iPod Cable.
If the battery has been completed dis-
charged, charge the device for at least 10
minutes before connecting.
Turn on the device before connecting.
If the device is set to lock, release the lock
before connecting.
For iPhones, audio will not play if the audio
system and BT are paired. Disconnect the
pairing before connecting.
PRE-OVERVIEW 2-23
When there are no songs in the iPod or
iPhone or if there is no response from the
device after connecting with the Hyundai
Cable, a "No Media Connected" pop-up mes-
sage will be displayed for 5 seconds and the
previous mode will automatically be restored.
In such cases, disconnect the iPod or iPhone
and try connecting again.
If the message continues even after recon-
necting the iPod, check to see if there are any
problems with the iPod device.
CAUTION!
If a playing iPod is connected to the audio sys-
tem, a high-pitched tone may occur for
approximately 1-2 seconds.
Please turn the iPod device to pause/stop
prior to connecting it to the vehicle.