Depth Gauge - Makita HR1840 Instruction Manual

Insert the drill bit into the tool. Turn the drill bit and push
it in until it engages.
After installing the drill bit, always make sure that the
drill bit is securely held in place by trying to pull it out.
► 1 . Drill bit
To remove the drill bit, pull the chuck cover down all the
way and pull the drill bit out.
2
► 1 . Drill bit 2. Chuck cover

Depth gauge

The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole on the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip
irmly.
1
2
► 1 . Hole 2. Depth gauge
NOTE: Make sure that the depth gauge does not
touch the main body of the tool when attaching it.
Dust cup (optional accessory)
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the igure. The size of bits which the dust cup can be
attached to is as follows.
1
Model
Dust cup 5
Dust cup 9
► 1 . Dust cup
1
Dust cup set (optional accessory)
NOTICE:
optional accessory, the standard side grip cannot
be used with the dust cup set being installed on
the tool. When the dust cup set is installed on the
tool, remove the grip from the standard side grip, and
then attach it to the optional grip base set.
7 ENGLISH
Bit diameter
6 mm - 14.5 mm
12 mm - 16 mm
If you purchase the dust cup set as
1