3.6.3 Quick Calibration
Note
: Users must carry out the calibration under those conditions below:
The first time to use the printer since installation;
The first time to use the printer since sensor cleaning;
Reuse the printer that has not been used for a long time;
Change a new type of media;
Printer cannot recognize the mark;
Huge change of operating environment;
Calibration method:
1) Carry out calibration manually.
2)Carry out calibration by printer utility. See more information in Label Printer Utility
Instructions.
Calibrate Manually:
When printer is ready, hold the FEED button for 3s until the Status Indicator(Blue) flash twice
and then release the button, printer start to do the calibration; When printer do the calibration
under Continuous Media Mode, the calibration is invalid.
Note: After the quick calibration, users could open the printer cover to pull back the
learned paper in avoid of paper wasting.
Rev. 1.0
HT100 User Manual
20