Table of Contents
Advertisement
2) Connect the curved end of the hose to the water inlet valve located at
the rear right hand top corner of the unit. Ensure the connection is
tightened adequately so that it will not leak.
3) Make sure there a no kinks or bends in the hose.
4) Turn on the tap and check that there are no leeks from either
connection.
! For the machine to work efficiently the water pressure must be 0.1-1
MPa
! Lengthening of the hose must only be done by an authorised Service
Engineer.
Water Drain Connection
The drain hose is located on the rear of the machine.
The drainage outlet must be located between 60 and 100 cm in
height from the floor.
Connect the drain hose to the drainage outlet
Ensure the hose is not kinked or bent.
! Do not attempt to lengthen the drain hose.
! If the hose end is placed in a sink, ensure the end is not underwater.
Swan Helpline No. 0845 610 4118
Max.
100cm
Min.
60cm
6
Advertisement
Table of Contents
