Page 2
Congratulations! You have bought a great, innovative product from DAP Audio. DAP Audio ER-216 brings excitement to any venue. Whether you want simple plug-&-play action or a sophisticated show, this product provides the effect you need. You can rely on DAP Audio, for more excellent audio products.
WARNING CAUTION! Keep this system away from rain and moisture! FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! Unpacking Instructions Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all parts are present, and have been received in good condition.
Always operate the unit with the AC ground wire connected to the electrical system ground. Make sure you don’t use the wrong kind of cables or defective cables. Please turn off the power switch, when changing the AC- adaptor or signal cable, or select the input mode switch.
Backside Fig. 1 Antenna A AF Balanced XLR Output RX2 AF Balanced XLR Output RX1 RX2 Squelch AF Unbalanced Mixed Output RX1 Squelch DC Input 12-18V/600mA Antenna B LCD Display RF incoming signal level of RX1 RF incoming signal level of RX2 AF incoming signal level of RX1 AF incoming signal level of RX2 Diversity of RX1 (antenna A or B active)
Installation Remove all packing materials from the ER-216. Check that all foam and plastic padding is removed. Connect all cables. Always disconnect from electric mains power supply before cleaning or servicing. Damages caused by non-observance are not subject to warranty.
2. Setting Lock-on After selecting channel, repress the Up and Down buttons till the HOLD starts flashing simultaneously, and the current setting is saved in memory on switch off. 3. Adjusting Squelch level With the squelch level control in the rear panel, you can adjust the squelch at a suitable level. If the level is set too high, the transmission range will be reduced.
Declaration OF CONFORMITY This certifies that the following designated product: Name: ER-216 2Ch 16 Freq PLL 790-814 MHz Receiver Model No.: D143079 Brand Name: DAP AUDIO (Product Identification) Authorized by the European Union to act as Conformity Assessment Body in accordance with the R&TTE Directive 1999/5/EC EN 300 422-2 V1.2.2(2008-03)
Page 11
Declaration OF CONFORMITY This certifies that the following designated product: Name: ER-216 2Ch 16 Freq PLL 822-846 Receiver Model No.: D143082 Brand Name: DAP AUDIO (Product Identification) Authorized by the European Union to act as Conformity Assessment Body in accordance with the R&TTE Directive 1999/5/EC EN 300 422-2 V1.2.2(2008-03)
Attaching the 19” flaps Connection Cables Take care of your cables, always holding them by the connectors and avoiding knots and twists when coiling them: This gives the advantage of increasing their life and reliability. Periodically check your cables. A great number of problems (faulty contacts, ground hum, discharges, etc.) are caused entirely by using unsuitable or faulty cables.
Maintenance DAP Audio ER-216 requires almost no maintenance. However, you should keep the unit clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in liquid. Do not use alcohol or solvents.
Product Specification Model: DAP Audio ER-216 Power AC 230V-50Hz (CE) Dimensions 450 x 215 x 55 mm (LxWxH) Weight 2.0 Kg Design and product specifications are subject to change without prior notice. Website: www.Dap-audio.info Email: service@highlite.nl...