Makita 4323 Instruction Manual page 9

Bevel cutting
CAUTION:
*Always be sure that the tool is switched off and unplugged before tilting the tool base.
Raise the dust cover all the way before making bevel cuts.
With the tool base tilted,
you
can make
bevel cuts at any angle between 0" and 45"
(left or right).
/
I
Loosen the bolt on the back of the tool base
with the hex wrench. Move the tool base
so
that the bolt is positioned in the center
of the cross-shaped slot in the tool base.
Tilt the tool base until the desired bevel
angle is obtained. The edge of the motor
housing indicates the bevel angle. Check
the contact between the back edge of the
blade and the roller, then tighten the bolt to
secure the tool base.
Indicate A
9