Tuner Menu - Shure GLXD6 User Manual

Tuner Menu

Enter tuner mode by pressing the footswitch. In tuner mode, the controls will only affect tuner functions. Receiver RF setting will not be affected.
Tuner Options
• Indicator: Needle or Strobe
• Output: Live or Mute
• Display Brightness
• Detune
• Sharps and Flats
• Frequency Offset
Indicator: Needle or Strobe
The tuner indicator can be set to display a needle style or strobe style.
Needle
A single LED will illuminate on
the tuning bar to indicate sharp
or flat. The green center LED will
illuminate when the note is in tune.
N..e..e..d..l..e
Note: Indicator and Output settings are displayed in a scroll from left to right.
Output: Live or Mute
The audio output can be set to Live or Mute in tuning mode:
• Audio is passed to the amplifier or mixer
Live:
• Audio is muted at the pedal output
Mute:
L....i....v....e
Note: Indicator and Output settings are displayed in a scroll from left to right.
Display Brightness
The receiver has a built-in light sensor to automatically adjust the display
brightness.
To manually adjust the brightness choose one of the following settings:
* A * 1
= automatic = low
*A *1
Selecting and Editing Tuner Menu Settings
Use the following buttons to select and edit the tuner
menu settings:
• Use the mode button access the menu and to
scroll between menu settings
• Use the Use ▲ ▼ buttons to change a menu
parameter
• Use the footswitch to enter and save parameter
changes
Strobe
A sequence of three LEDs will
travel across the tuning bar in the
direction of sharp or flat. The LEDs
will remain stationary when the
note is in tune.
S..t..r..o..b..e
M....u....t....e
* 2 * 3
= medium = high
*2 *3
Detune
The Detune feature can detect instruments that have been detuned up to
2 semitones (half steps).
The display will indicate the detuning as follows:
b 0
= Standard Tuning
b1
b0
Note: Two dots appear in the display as a reminder that the pedal is detuned.
Sharps and Flats
Adds sharp or flat symbols to the display of non-natural notes.
# b
Sharps and Flats
Frequency Offset
Frequency Offset adjusts the reference frequency from A440. The range
of adjustment is 432 Hz to 447 Hz in 1 Hz increments.
When adjusting the frequency, the last 2 digits of the value will be show.
For example, "32" would appear on the display when the frequency has
been set to 432 Hz.
Note: Two dots appear in the display as a reminder that the reference frequency is offset.
432 Hz
link group
M...e...n...u
mode auto rf channel
b 1
b 2
= 1 Semitone = 2 Semitones
b2
b
Flats only Sharps only
A440
#
447 Hz
11