55702_Sec05-2_'08 08.2.12 9:51 AM Page 53
ROOF MARKER LIGHT (IDENTIFICATION LIGHT / CLEARANCE
LIGHT)
1. Unfasten the screws of the lens, and remove the lens.
2. Pull out the bulb and replace it with a new one.
3. Install the lens and screw.
NOTICE: If the screwing procedure is inadequate, water may
infiltrate into the light unit.
WORKING NEAR BATTERY
CAUTION: Follow the precautions listed in the jump starting caution
(see "Emergency starting your vehicle due to a discharged battery"
in Section 3) when working on or near the battery. Personal injury
(particularly to eyes) or property damage may result from battery
explosion, battery fluid or electrical (short circuit) burns.
Lens
Socket
Screw
Bulb
5-53