Table of Contents
Advertisement
11. When finished with the pass, lift the planer away
from the workpiece. Wait for the blade to come
to a complete stop before setting down.
12. Continue using progressive cuts until near the
desired depth. Set the adjustment knob to a
very shallow depth for the final passes. This
will ensure a smooth finish.
13. Empty and clean the dust bag thoroughly when
it becomes about half-full and upon completion
of a job.
Types of Cuts
Rabbeting, Shiplapping
Rabbeting, or shiplapping, is a type of step cut
achieved by making repetitive passes. Use the
guide fence to ensure a straight cut.
1. Align the blade edge with the cutting line and
secure the guide fence against the side of the
workpiece.
2. Keep the edge of the fence against the workpiece
as the planer is moved through the workpiece.
3. Repeat until the desired depth is reached. Maxi-
mum rabbeting depth is 13 mm (1/2").
Chamfering
Chamfering is a type of angle cut. Use the guide
fence to ensure the same angle is cut during each
repetitive pass.
1. Align the chamfer groove in the front shoe with
the edge of the workpiece at the desired angle.
2. Secure the guide fence against the side of the
workpiece, using the bevel thumb screws.
3. Keep the edge of the fence against the workpiece
as the planer is moved through the workpiece.
4. Repeat until the desired chamfer is reached.
45 。
MAINTENANCE
WARNING
always unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disas-
semble the tool, battery pack or charger.
Contact a MILWAUKEE
ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good repair by
adopting a regular maintenance program. After six months to
one year, depending on use, return the tool, battery pack and
charger to the store where the product was originally
purchased or one of our authorised MILWAUKEE ® service
centres for:
• Lubrication
• Mechanical inspection and cleaning (gears, spin-
dles, bearings, housing, etc.)
• Electrical inspection (battery pack, charger,
motor)
• Testing to assure proper mechanical and electrical
operation
If the tool does not start or operate at full power with a fully
charged battery pack, clean the contacts on the battery pack.
If the tool still does not work properly, return the tool, charger
and battery pack, to the store where the product was
originally purchased or one of our authorised MILWAUKEE ®
service centres for repairs.
WARNING
sonal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow
a liquid to flow inside them.
Cleaning
Clean dust and debris from charger and tool vents.
Keep tool handles clean, dry and free of oil or
grease. Use only mild soap and a damp cloth to
clean the tool, battery pack and charger since certain
cleaning agents and solvents are harmful to plastics
and other insulated parts. Some of these include
gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and house-
hold detergents containing ammonia. Never use
flammable or combustible solvents around tools.
Repairs
For repairs, return the tool, battery pack and charger to
the store where the product was originally purchased or
one of our authorised MILWAUKEE ® service centres.
ACCESSORIES
WARNING
before changing or removing accessories.
Only use accessories specifically recommend-
ed for this tool. Others may be hazardous.
For a complete listing of accessories refer to your
MILWAUKEE ® accessories catalogue or go online to
www.milwaukeetools.com.au or www.milwaukeetools.co.nz
To obtain a catalogue, contact the store where the product
was originally purchased or one of our authorised
MILWAUKEE ® service centres.
6
To reduce the risk of injury,
®
service facility for
To reduce the risk of per-
Always remove battery pack
Advertisement
Table of Contents
