Table of Contents
Advertisement
7. How to supply target board from CoLinkEx
With CoLinkEx adapter, you can supply target board with 3.3V/400mA or 5V/400mA via JTAG connector.
7.1. Power supply with 3.3V
For using this function, you must close "3V3" jumper. In this case, 3.3V from on-board voltage
regulator will be connected to pin 1 of JTAG connector. On target board 3.3V power supply bus
must be connected to pin 1 of JTAG connector.
7.2. Power supply with 5V
For using this function, you must close "5V" jumper. In this case, 5V from USB will be connected
to pin 19 of JTAG connector. On target board, 5V power supply bus must be connected to pin 19
of JTAG connector.
CoLinkEx JTAG/SWD adapter
www.bravekit.com
"3V3" jumper
"5V" jumper
7
Advertisement
Table of Contents
