Table of Contents
Advertisement
8.2. Connect CoLinkEx to PC
When you connect CoLinkEx to PC, it will ask you to install the driver to system for the new detected
devices. Then you may need to specify the path for CoLinkEx Driver. After you installed the driver, in the
device manager, you will found CooCox（COM x）under Port and CooCox CoLinkEx Debug Interface
under USB Controller. If there is a "?" in front of the two devices, it means that the driver have not been
installed to the system or install failed; if there isn't CooCox Port, it means that your CoLinkEx firmware
and driver is old version.
9. Update the firmware
You can download firmware from
How to update the firmware:
9.1. Short-circuit JP1 (activation of USB bootloader)
9.2. Connect CoLinkEx to the PC. Wait for the PC enumerates the removable disk whose label is
"CRP2 ENABLD" or "CRP DISABLD". If it does not, you could press the reset button (BP1) for
several times or power on again.
9.3. Delete the firmware.bin file in removable disk
9.4. Copy the downloaded firmware: ColinkEx_firmware_v0.4.bin into the removable disk
9.5. Disconnect JP1, power on again, then CoLinkEx will work normally
CoLinkEx JTAG/SWD adapter
http://www.coocox.org/Colinkex.htm
www.bravekit.com
10
Advertisement
Table of Contents
