Operation; Location Of Controls; On/Stop Switch - Poulan Pro PP4620AVHD Instruction Manual

Chain Brake
Nuts
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment Tool
(Bar Tool)
Bar Sprocket
Chain
Hole
Bumper
Spike
Cylinder Cover
Throttle
Lock- -out
Rear
Handle
Throttle
Trigger
Chain Brake
Choke/Fast Idle Lever

ON/STOP SWITCH

The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LOCK ---OUT
The THROTTLE LOCK- -OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle speed are set by pull-
ing the CHOKE/FAST IDLE LEVER out fully
for cold or for refueled starting. The choke
provides additional fuel to the engine during
cold starting.
WARNING:
with a loose chain, the chain could jump off
the guide bar and result in serious injury.

OPERATION

Front Handle
Front Hand Guard
Muffler
Bar Oil
Fill Cap
Starter Housing
Adjusting
Screw
Chain Brake Nuts
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs. The chain
brake activates automatically in the event of
kickback. The chain brake activates manu-
ally if the front hand guard is pushed forward.
The chain brake is disengaged by pulling the
front hand guard back toward the front han-
dle as far as possible.
CHAIN TENSION
It is normal for a new chain to stretch during first
30 minutes of operation. You should check
your chain tension frequently. See CHAIN
TENSION in the ASSEMBLY section.
WARNING:
ing and after use. Do not touch the muffler or
allow combustible material such as dry
grass or fuel to do so.
8
If the saw is operated
Starter Rope
ON/STOP
Switch
Fuel Mix Fill Cap
Direction
of Chain
Travel
Guide Bar
Muffler is very hot dur-