Poulan Pro PP300E Instruction Manual page 9

POWER CORD
The is used to connect
POWER CORD
the chain saw to an approved extension
cord.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified on
your unit.
SELECT AN EXTENSION CORD
Extension cords are available for this unit .
MINIMUM WIRE GAUGE
RECOMMENDATIONS
50 ft.
25 ft.
Volts
(7.67 M) (15.24 M)
16 16
120
A.W.G.* A.W.G.*
*American Wire Gauge
ATTACH THE EXTENSION CORD TO
YOUR CHAIN SAW
To prevent disconnection from unit, se-
cure extension cord to power cord as
shown in the following illustration.
Power Cord
Extension Cord
BEFORE STARTING SAW
WARNING:
Be sure to read the
electrical safety information in the safety
rules section of this manual before you
begin. If you do not understand the elec-
trical safety information do not attempt to
use your unit. Seek help from someone
that does understand the information or
call the customer assistance help line at
1-800-554-6723.
GUIDE BAR AND CHAIN OIL
The bar and chain require lubrication. The
chain oiler provides lubrication to the
chain and guide bar. Be sure to fill the bar
oil tank before each cutting session. Lack
of oil will quickly ruin the bar and chain.
Too little oil will cause overheating shown
by smoke coming from the chain and/or
discoloration of the bar. For maximum
guide bar and chain life, we recommend
you use Poulan or Poulan
saw bar oil. If Poulan or Poulan
oil is not available, you may use a good
grade SAE 30 oil until you are able to ob-
tain Poulan or Poulan ProR brand. Use a
funnel to fill the tank. Replace oil cap se-
curely. Check oil level after every 15 min-
utes of operation.
CHAIN TENSION
It is normal for a new chain to stretch dur-
ing first 30 minutes of operation. You
should check your chain tension frequent-
ly. See
CHAIN TENSION
VICE AND ADJUSTMENTS
CHAIN BRAKE
Ensure chain brake is disengaged by pull-
ing the front hand guard back toward the
front handle as far as possible. The chain
brake must be disengaged before cutting
with the saw.
STOPPING YOUR SAW
S Release the trigger switch.
100 ft.
S If motor does not stop, disconnect
(30.48 M)
the extension cord. Discontinue use
14
of the unit until it has been repaired
A.W.G.*
by an authorized service dealer.
STARTING YOUR SAW
S Connect the saw to a power source
using the proper size extension cord
see
SELECT AN EXTENSION CORD
the
OPERATION
S Grip both handles firmly.
S Push and hold the trigger lock--out
button with your right hand thumb.
S Squeeze and hold the trigger switch.
CHAIN BRAKE
WARNING:
worn too thin it may break when the chain
brake is triggered. With a broken brake
band, the chain brake will not stop the
chain. The chain brake must be replaced
if any part is worn to less than 1/32" thick.
Repairs on a chain brake should be made
by your authorized service dealer. Take
your unit to the place of purchase or to the
nearest authorized service dealer.
S This saw is equipped with a chain
brake. The brake is designed to stop the
chain if kickback occurs.
S The inertia--activated chain brake is ac-
tivated if the front hand guard is pushed
forward, either manually (by hand) or
automatically (by sudden movement).
S If the brake is already activated, it is dis-
engaged by pulling the front hand guard
back toward the front handle as far as
possible.
S When cutting with the saw, the chain
brake must be disengaged.
ProR chain
Disengaged
ProR bar
9
under the
SER-
section.
;
in
section).
If the brake band is
Engaged