Maintenance - Poulan Pro PP300E Instruction Manual

S Remove larger branches with the cut-
ting techniques described
WITHOUT A SUPPORT.
S Always use an overcut to cut small and
freely hanging limbs. Undercutting
could cause limbs to fall and pinch the
saw.
PRUNING
WARNING:
Limit pruning to limbs
shoulder height or below. Do not cut if
branches are higher than your shoulder.
Get a professional to do the job.
S Make your first cut of the way
1/3
through the bottom of the limb. This
cut will make the limb sag so that it
falls easily on the second cut.
S Next make a second cut all the way
through the limb.
CUSTOMER RESPONSIBILITIES
WARNING:
Disconnect power source before performing maintenance.
Fill in dates as you complete
regular service
Check for damaged/worn parts
Check for loose fasteners/parts
Check chain tension
Check chain sharpness
Check guide bar
Check bar and chain oil level
Lubricate bar sprocket hole
Inspect and clean unit & labels
Clean guide bar groove
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover
items that have been subjected to oper-
ator abuse or negligence. To receive full
value from the warranty, the operator
must maintain unit as instructed in this
manual. Various adjustments will need
to be made periodically to properly
maintain your unit. Improper mainte-
nance may cause damage to the unit
and possible injury to the operator or by-
standers.
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for
replacement of worn or damaged parts.
NOTE: It is normal for a small amount of
oil to appear under the saw after motor
S Finish the pruning operation by using
an overcut so that the stump of the
BUCKING
limb protrudes 1 to 2 inches (3--5 cm)
from the trunk of the tree.
Second cut

MAINTENANCE

Before After
Use Use
n
n
n
n
n
n
n
n
n
stops. Do not confuse this with a leaking
oil tank.
S Trigger Switch -- Ensure the trigger
switch functions properly by squeezing
and holding the trigger switch. Make
sure motor starts and stops.
S Oil Tank -- Discontinue use of chain saw
if oil tank shows signs of damage or
leaks.
S Extension Cord -- Discontinue use if
chain saw extension cord shows signs
of damage or wear.
CHECK FOR LOOSE FASTENERS
AND PARTS
S Bar Clamp Nuts
S Chain
S Bar Adjusting Screw
13
First cut
1/3 of way
3rd cut 1 to 2 in.
(3--5 cm) from
trunk of tree
Every Service
15 min. Dates
n