Table of Contents
Advertisement
Bar Nuts
6. Use the screwdriver end of the bar tool
to move chain around guide bar.
7. If chain does not rotate, it is too tight.
Slightly loosen bar nuts and loosen
chain by turning the adjusting screw
turn counterclockwise. Retighten bar
nuts.
KNOW YOUR CHAIN SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
Chain
Front Hand Guard
Adjustment Tool
(Bar Tool)
Chain
Bar Oil Fill Cap
Bar
Sprocket
Hole
Cylinder Cover
Throttle
Lockout
Rear
Handle
Throttle Trigger
Clutch Cover
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LOCK- -OUT
The THROTTLE LOCK- -OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
8. If chain is too loose, it will sag below the
guide bar. DO NOT operate the saw if
the chain is loose.
NOTE:
when the weight of the chain does not cause it
to sag below the guide bar (with the chain saw
sitting in an upright position), but the chain still
moves freely around the guide bar.
WARNING:
with a loose chain, the chain could jump off the
guide bar and result in serious injury to the op-
erator and/or damage the chain making it un-
1
/
usable. If the chain jumps off the guide bar, in-
4
spect each drive link for damage. Damaged
chain must be repaired or replaced.
OPERATION
Front Handle
Muffler
Starter Housing
Fuel Mix Fill Cap
Chain
Brake
Adjusting Screw
Chain
Catcher
Bar Nuts
CHOKE/FAST IDLE LEVER
The choke and fast idle are set by pulling the
CHOKE/FAST IDLE LEVER out to the full ex-
tent for cold starting or after refueling. The
choke provides additional fuel to the engine
during cold starting.
PRIMER BULB
The PRIMER BULB circulates fuel to the car-
buretor to provide quicker starting.
8
The chain is tensioned correctly
If the saw is operated
Starter Rope
ON/STOP
Switch
Choke/
Fast Idle
Lever
Primer Bulb
Chain
Direction
of Travel
Guide Bar
Advertisement
Table of Contents
