Table of Contents
Advertisement
DSST~2801~B.qxd 1/25/2003 7:03 PM Page 2
Cordless Telephone Operation
Placing Calls
1. Press the
button. "Talk" will display and the Call
TALK
Timer starts to count.
2. Wait until you hear a dial tone and then dial the
phone number.
3. When you have finished your call, press the
ton again or place the HANDSET on the BASE UNIT.
The duration of the call will be displayed on the LCD
Screen for about 3 seconds.
OR
1. Dial the phone number.
2. Press the
button. The number displayed will be
TALK
dialed.
3. When you have finished with your call, press the
button again or place the HANDSET on the BASE
UNIT. The duration of the call will be displayed on the
LCD Screen for about 3 seconds.
HANDSET Volume Control
1. To adjust the HANDSET receiver volume level while
having a conversation, press the
VOL
The LCD Screen will display "volume setting."
2. The default setting is "Low." Press the SCROLL
UP
or DOWN
button, or press the TELE-
PHONE KEYPAD
to
button to select the
1
4
desired setting from Low, Medium, High or Maximum.
Redial Feature
1. If you get a busy tone, press the
TALK
the HANDSET on the BASE UNIT to hang up.
2. Later, press the
button again.
TALK
3. Listen for a dial tone.
4. Press the
/RE/PA button. This will automati-
SAVE
cally redial the last telephone number you called.
5. When you have finished with your call, either press the
button again or place the HANDSET on the
TALK
BASE UNIT.
11
but-
TALK
TALK
/MENU button.
button or place
1, 2, 5
4
Cordless Telephone Operation
Extension In Use Indicator
This telephone can detect when a HANDSET is already
in use. The LCD Screen of all of the HANDSETS linked
to the same BASE UNIT will display "Ext in-use." This
means you will have to wait until the line is free to make
a call.
Using the Headset Feature
Your HANDSET, when connected to a headset (not
included),
will
provide
you
with
hands-free
communication.
Pull out the HEADSET JACK COVER then insert the
small plug on the end of the headset into the HEADSET
JACK on the left side of the HANDSET. Follow the
procedures discussed in "Receiving Calls" and "Placing
Calls" to receive and place a call.
NOTE:
When you plug the headset plug into the HEADSET
JACK it automatically mutes the MICROPHONE and
SPEAKER of the HANDSET. Unplug the headset to
return the HANDSET to normal use.
Headsets are available at most retail outlets that sell
telephone equipment. The HEADSET JACK is
compatible with 2.5 mm headset plugs only.
IMPORTANT
In order to utilize the Caller ID feature, you
must subscribe to Caller ID service from
your local telephone company.
12
HEADSET
MICROPHONE
SPEAKER
HEADSET JACK
COVER
HEADSET PLUG (2.5mm)
HEADSET JACK
Advertisement
Table of Contents
